First, the engine will not start every morning when you're in the car, ready to leave, Peugeot Crankshaft they found the engine fails to start, which is something very very upset. But sometimes, the engine can not be started, but because of some small problems caused if you understand these reasons, we can solve the problem as soon as possible. First check distributor, spark plugs, power lines, etc., etc. Is it because the car rain moisture, and if so, can the damp parts dry, then launch. Second, check the spark plug is damaged, if damaged, can be as long as the replacement of the fire plug. Third, check the battery voltage is adequate. Sometimes, parking lights forget, a long time, you may run out of power. If so, the car linked to the second block, foot clutch, drag car, when traveling to a certain speed, release the clutch, twist the ignition switch, the car will be able to naturally start, if there is a battery problem, this method can not be work.

Second, turn off the engine when the shift marching shift, if the operating specifications, but flameout phenomenon occurs, you need to check the following problems: First look at the stability of the idle, idle speed is too low, or if the unstable idle idling low, as long as the idle adjustment to normal speed can be. But also to tighten the idle shut-off valves, plug tight. Secondly, if the normal idle speed, it may be clogged oil separator is required to repair station specializing in cleaning oil separator.

Third, when a high-speed car steering wheel tremors occur with instability at high speeds or when traveling at a high speed, swing, and even the steering wheel shake, the reasons for this situation are the following:

A wheel alignment angle misalignment, excessive toe.

2, the front tire pressure is too low or tire repair and other reasons due to start imbalance.

3, the front tire spokes deform or unequal number of bolts.

4, transmission parts installed loose.

5, the drive shaft is bent, the power imbalance, the front axle deformation.

6-speed oscillation damper failure, there are two cases, one with improved speed runout getting intense, two appeared at a high speed runout, and cause the steering wheel shake. You can put up to the drive axle, front safety plug stopper block, start the engine and gradually shift into high gear, the drive wheel shimmy to reach the final speed test. If at this time the body and the steering wheel shakes, for the transmission caused by runout.

Because the front wheel axle in a quiescent state, if runout try to reach the final speed, the car does not appear jitter, the runout of the reason is the existence of a fault before the bridge part of the car; check the front wheel angle and the toe meets the requirements, such as misalignment should be adjusted; erected front axle wheels turn test, check wheel balancing and tire is deformed situation is too big. If necessary, change the wheels good comparison test; check the front axle, frame is deformed, check whether the shaft is bent driveshaft balancing conditions should be doing.

Fourth, the steering heavy heavy steering many reasons, hilux turbocharger but usually there are the following:

A tire pressure inadequate, particularly lack of front wheel pressure, steering will be more difficult.

2, the power steering fluid deficiency, add power steering fluid.

3, wheel positioning, the need for wheel alignment test.

Fifth, when driving wandering checking deviation, usually when driving, straighten the steering wheel, then release the steering wheel travel, to see if the car straight. If you do not walk a straight line, that is deviation. First deviation may be inconsistent because about tire pressure caused by insufficient demand for tires inflated. Secondly, the front wheel alignment may be allowed. Camber, kingpin angle or kingpin interior angles ranging from small or negative toe toe will cause deviation, must go to a professional service station testing.